Parquet and adhesion technology
SPECIAL DESIGN COVERING ADHESIVE X-BOND MS-K499
- without migrating components
- highly thermally load-bearing
- hard-elastic adhesive joint
Single-component special adhesive tested according to DIN EN 14259 on STP polymer base for adhesion of LTV design covers, homogeneneous and heterogeneous PVC covers in membranes and tiles, CV covers, rubber coverings in membranes and tiles (up to 10 mm, higher covering thicknesses in consultation), protective sluices, and artificial turf coverings. For the adhesion of absorbent and non-absorbent substrates indoors and outdoors. Specially formulated for raised thermal and mechanical load and/or increased wet load. The adhesive is also suitable for special rubber and recycling mats. In these instances, however, sample adhesions are required. For non-absorbent substrates, a relative air humidity of min. 50% is required, as well as observing a corresponding flash-off time of approx. 10-20 minutes.
Recommended toothing for standard coverings: A1 toothing consumption approx. 300 - 350 gr/m² A2 toothing consumption approx. 370 - 420 gr/m² B1 toothing consumption approx. 400 - 450 gr/m² B2 toothing consumption approx. 500 - 580 gr/m²